Skip to content
Ashburn Lock & Key Co.Request a visit
Open 24/7(289) 278-0778Call now
Person holding a rectangular door-hardware housing at a table with additional metal assemblies beside a glass entrance. — Access Control Installation, Whitby

Plan ahead Commercial · Whitby

Access Control Installation

Something went missing from the storeroom over a weekend, and when you ask who was in the building, the honest answer is anyone with a key. There is no list, no time stamp, no way to narrow it down.

Call now · open 24/7(289) 278-0778

Request a visit

In plain words

Credentials take several forms, and most installations end up mixing them: a proximity card or fob held near a reader, a keypad code typed at the door, or a mobile credential read from a phone. Cards and fobs are simple to hand out and just as simple to switch off if lost; a code needs no hardware to issue but has to be changed once shared too widely; a mobile credential ties entry to a device the person already carries. The mix is chosen door by door, based on who uses each one and how often.

Sound familiar?

Another employee left and the keys never came back. You changed the locks again, cut copies for everyone who stayed, and paid for a job that repeats itself the next time someone quits, taking a working key out the door with them.

How the visit goes

Access Control Installation · Whitby

How the visit goes

Illustrative locksmith scene
  1. 1

    Checking which doors are also exits

    A door that leads outside along a path people use to leave the building gets special attention, no matter what lock currently sits on it, so the survey flags every one of those openings early. On an exit door, a magnetic lock only gets considered alongside a request-to-exit device and a tie-in to the fire alarm system, while an electric strike paired with a standard latch usually needs no extra hardware to let people out. Sorting exit doors from interior doors before any hardware is ordered keeps a smooth, one-motion exit part of the plan from day one rather than a fix added afterward.

  2. 2

    Fitting an electric strike

    Where the frame allows it, an electric strike replaces the fixed keeper the latch normally strikes against, so the door keeps its existing latch and lockset and simply releases the strike plate when a valid credential is presented. The locksmith mortises the frame to fit the strike body, runs a low-voltage cable within the frame or jamb back to the controller, and sets the strike to hold the door secure until the controller sends a release signal. Because the latch itself never changes, the door still closes and locks normally by hand at any time, credential or no credential.

  3. 3

    What the system adds to the rest of the building's security

    Once the installation settles into daily use, its value tends to show up alongside whatever else the business already runs: an alarm event that lines up with the person who unlocked the door that morning, a camera clip that can be matched to a specific credential instead of just a timestamp, or a plain answer, finally, to who was in the building last weekend. Getting there can mean linking the access system to the alarm panel or the camera platform, which sometimes calls for extra configuration or an integration licence beyond the original installation, but the controller and the log it already keeps are the starting point either way.

In the van

  • Access control panel
  • Card and fob readers
  • Low-voltage cable
  • Mechanical override cylinders
  • Request-to-exit devices

What affects the quote

  1. 1

    How many credentials and what type

    Cards, fobs, keypad codes and mobile credentials each involve different issuing steps, and a system enrolling a handful of managers is a shorter task than one enrolling an entire staff across several shifts.

  2. 2

    Electric strike or magnetic lock

    An electric strike works with the door's existing latch and generally needs less additional hardware than a magnetic lock, which also calls for a request-to-exit device and, on an exit door, a fire alarm tie-in.

  3. 3

    Room left for future doors

    Sizing the controller and power supply with some spare capacity for a door or two added later costs a little more at installation but avoids a second controller purchase when the building later adds an opening.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(289) 278-0778

Access Control Installation: questions

Advice · (289) 278-0778

Is a keypad code as secure as a card or fob?

A keypad code needs no card to lose, but a code shared among several people is effectively no longer individual, and a forgotten code left active is a common weak point. A card or fob tied to one named person avoids that particular issue, since it is switched off individually rather than reset for everyone at once. Many businesses use a code for general areas and a card wherever entry needs to be traceable to one person.

Can a person's access change automatically by time of day or day of the week?

Yes. Access levels can be set to change automatically by time of day or day of the week, so a credential that opens a door during a shift can be denied outside it without anyone having to remember to switch it off manually. This is set up once in the schedule and then runs on its own from that point forward.

Can different doors run on different schedules?

Yes, and this is one of the more useful parts of the system. A front office can unlock for regular business hours, a stockroom can allow only two credentials at any hour, and a loading dock can release only during a set delivery window. Schedules are set per door and per access level in the controller, and can be changed at any time without touching the hardware itself.

Access Control Installation near you

Durham, Ontario

Whitby information

Town
Whitby, Durham, Ontario
In business
13 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

25%

Newer homes. About 25% of homes in Whitby were built in 1980 or earlier, according to the 2021 Census.

Recent builds often have steel or fibreglass entry doors rather than solid wood. They resist warping and take hardware well, and a locksmith fitting a deadbolt or reinforced strike works with the door's construction so screws bite into something solid.

70%

Mostly houses. Single-detached houses make up about 70% of homes in Whitby (2021 Census).

A detached house gives a locksmith room to work: full access to both sides of every door, hinges and frames included. Repairs and upgrades can be thorough, from the front deadbolt to the gate latch, with nothing off limits.

Source: Statistics Canada, 2021 Census of Population

Open Whitby in Google Maps

Open 24/7

Request a visit

Something went missing from the storeroom over a weekend, and when you ask who was in the building, the honest answer is anyone with a key.

Call now · open 24/7(289) 278-0778
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 13 years in business